m8ta
You are not authenticated, login.
text: sort by
tags: modified
type: chronology
{830}
hide / / print
ref: Rolston-2009.01 tags: ICMS artifacts stimulation Rolston Potter recording BMI date: 01-03-2012 02:38 gmt revision:3 [2] [1] [0] [head]

PMID-19668698[0] A low-cost multielectrode system for data acquisition enabling real-time closed-loop processing with rapid recovery from stimulation artifacts

  • Well written, well tested, but fundamentally simple system - only two poles active high-pass, one pole low-pass.
  • With TBSI headstages the stimulation artifact is brief - figure 8 shows < 4ms.
  • Includes NeuroWriter software, generously open-sourced (but alas windows only - C#).

____References____

[0] Rolston JD, Gross RE, Potter SM, A low-cost multielectrode system for data acquisition enabling real-time closed-loop processing with rapid recovery from stimulation artifacts.Front Neuroengineering 2no Issue 12 (2009)

{834}
hide / / print
ref: Brown-2008.03 tags: microstimulation recording artifact supression MEA ICMS date: 12-28-2011 20:43 gmt revision:3 [2] [1] [0] [head]

IEEE-4464125 (pdf) Stimulus-Artifact Elimination in a Multi-Electrode System

  • Stimulate and record on the same electrode within 3ms; record on adjacent electrodes within 500us.
  • Target at MEAs, again.
  • Notes that very small charge mismatches of 1% or less, which is common and acceptable in traditional analog circuit designs, generates an artifact that saturates the neural amp signal chain.
  • for stimulating & recording on the same electrode, the the residual charge must be brought down to 1/1e5 the stimulating charge (or less).
  • paper follows upon {833} -- shared author, Blum -- especially in the idea of using active feedback to cancel artifact charge & associated voltage.
  • target the active feedback for keeping all amplifier out of saturation.
  • vary highpass filter poles during artifact supression (!)
  • bias currents of 1fA on the feedback highpass stage. yikes.

Brown EA, Ross JD, Blum RA, Yoonkey N, Wheeler BC, and DeWeerth SP (2008) Stimulus-Artifact Elimination in a Multi-Electrode System. IEEE TRans. Biomed. Circuit Sys. 2. 10-21

{832}
hide / / print
ref: Jimbo-2003.02 tags: MEA microstimulation artifact supression date: 12-17-2011 01:41 gmt revision:2 [1] [0] [head]

PMID-12665038[0] A system for MEA-based multisite stimulation.

  • stimulate and record the same MEA channel.
  • used voltage-control stimulation.
  • very low leakage current switches, DG202CSE, 100Gohm, Maxim, above. non-mechanical = low vibration.
  • switches switch between stimulator and preamp. obvious.
  • uses active shorting post-stimulation to remove residual charge,
  • uses active sample/hold of the preamplifier while the stimulator is connected to the electrodes.
  • adds stimulation pulse to the initial electrode offset (interesting!)

____References____

[0] Jimbo Y, Kasai N, Torimitsu K, Tateno T, Robinson HP, A system for MEA-based multisite stimulation.IEEE Trans Biomed Eng 50:2, 241-8 (2003 Feb)